PLC Ethernet Modul

Picture below is an Ethernet modul. It connect to the PLC on the left side and have a waterproof Ethernet connector on the right side. Again I have replaced the SWD connector at left bottom with TC2030. I don’t expect to be using so many of these since CAN/CAN-FD is the primary link technology, but having Ethernet capability is a must.

The connector used is a M12 waterproof connector. I was considering using GX16, but decided not to due to lack of IP67 support + M12 have more combinations and is a bit smaller as a GX16 uses ca 8 mm more PCB space.

Categories: PLC

Leave a Reply