XPortHub changes

I have not tested everything yet, but rev 1.1 of XPortHub need a few changes:

  • correct package on serial flash.
  • wap sequence on dip switch.
  • replace battery with a proper battery holder. Can be mounted on back-side if needed. This also fix the short-cut here.
  • Test Power Connector. I have a 2-pin connector that is right-angle and fit well. That should be ok as is.
  • Add Led’s if possible. I have a few spare pins and it would be nice with some more led’s.

These are just minor adjustments as the board seems to work fine!

Leave a Reply