PnP with Tank Belts

I finally got the two tank belts designed and added to the frame – so will get around to mount the plates and wire the machine. The tank belt at right hang a little so I will mount a holder to lift it up a bit, but otherwise I am good to go. My current “lab” is an old bed-room, so I need to clear the proper lab in the basement again before I start designing the cabinet for the machine.

I find designing with FreeCAD very easy once I got into it – very funny to design and print your own components. The picture don’t show the holders very well, but it is basically just boxes with screw holes ready printed using PETG plastic.

Categories: PLC

Leave a Reply